USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
This is to neet a little motor not to tell the world about! Hooked to a Yurnigy 12A plusl-12A-E on 3.75 timing and a 800mah 2S 20-30c produces 11.072 Oz of vertical lift with 7x4 APC prop and ran at just worm temp. A 7x5 Apc prop run for 20sec was to warm for my taste. Getting the APC props to run true was a *#$%*. Very nice looking little motor with a LOT of copper wound in it. Very strong for size! I can feel a bit of side to side play in shaft, but that could be the bearings being so close togeather.
Have fun and good flying
Sence my first post I've receaved a Mega Meter 7 in 1. Hooking it up to the above system showed 51 wats at 7.1 volts. This was just after a vertical lift of 11.07 oz. that consisted of the motor, stick it was atached to, Rx, ESC, battery, and a paper cup to witch was added #4 lead shot until it would lift no more. Good flying to Ya.
Kellyann, The more I fool with this motor the more inpressed I become, thears no dought in my mind that the poublished 74w. may be posable, but I'm fairly conserative. Notting your a Pro Contributor would you happen to know what tempatures the advrage motor and ESC is desined to run at? Thanks Frostbit.
frostbit it should let you. Anyway you did a great job of the revue. If you keep having this problem raise it in the "ISSUE" tab above. I may be a glitch.
Perfect little motor who I use on a homebuildracer with an 4.5*4.5prop and a 460 mah nanotech 3S li-po. Enough power to go fast and turn left and then to fly verticaly in the sky with enough speed for my 200gr. racer.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg&width=48)
